Print the plastic parts

If you have bought the plastic parts you can skip this step!

For this section you will need:

50 g of Black PLA filament
200 g of PLA filament - Of any colour you want. Two contrasting colours may look best.

The microscope body has a custom brim included in the STL. This may require custom print settings.

Now you have tested your printer and filament you can print the following parts:

Actuator assembly tools (nut tool, band tool, and band tool cover): actuator_assembly_tools.stl
Lens tool: lens_tool.stl
Main body: main_body.stl - The smart brim may require custom print settings.
3 cable tidy caps: cable_tidies.stl
Sample clips: sample_clips.stl
Microscope stand: microscope_stand.stl
Pi stand: pi_stand.stl
3 small gears: small_gears.stl
Illumination dovetail: illumination_dovetail.stl
Condenser arm: condenser.stl
Illumination thumbscrew: illumination_thumbscrew.stl
3 large gears: large_gears.stl
3 feet: feet.stl
Lens spacer: lens_spacer_picamera_2_pilens.stl - This must be printed in black!
pi camera platform: camera_platform_picamera_2_pilens.stl

Be careful when removing brim

To avoid injury first remove the bulk of the brim without a knife. Remove the remaining brim with a peeling action as described below.

Carefully remove the printing brim from all parts (except the main body).

To remove brim:

Use precision wire cutters to remove most of the brim from the part.
Clean up remaining brim with a utility knife:
- Hold the knife in your dominant hand with 4 fingers curled around the handle, leaving thumb free.
- Hold the part in your other hand, as far away from the surface to be cut as possible.
- Support the part with the thumb of your dominant hand.
- Place blade on surface to be cut, and carefully close your dominant hand moving the blade, under control, towards your thumb.