Mount the optics and the microscope

Step 1: Mount the optics

• Get the 2.5mm Ball-end Allen key ready
• Take the complete optics module and pass it through the bottom of the microscope.
• Insert exposed the mounting screw on the optics module through the keyhole on the z-actuator.

• Insert the Allen key through the teardrop shaped hole on the front of the microscope. Until it engages with the mounting screw.
• Slide optics module up the keyhole as high as it will go.
• Tighten the screw with the Allen key to lock the optics in place.

Step 2: Mount the microscope

• Place the microscope onto the microscope stand.
• The lugs on the microscope should sit on the lugs of the stand.
• Use four M3x10 cap head screws to fix the microscope in place using the same Allen key

Previous page | Next page