Block stage accessories
There are a number of accessories you can print for use with the block stage. Unfortunately we have not yet figured out how to print a good V groove, and we recommend you use a commercially available one.
Light sources
- CPS532_to_top_plate.stl mounts an 11mm diameter laser diode.
- LED_to_top_plate.stl mounts a 5mm LED (e.g. to back-illuminate a target).
Objective holder
- rms_to_top_plate.stl mounts an objective to the stage for fibre coupling.
Target holder
- vertical_sample_clips.stl holds a microscope slide vertically, allowing it to be used as a target to measure motion of the stage (e.g. in conjunction with the LED holder).
Microscope module
- microscope_module.stl attaches to the RMS mount, and allows a Raspberry Pi camera module and 12.7mm lens to form a microscope. This was used for the calibration of drift and precision in the paper. The optics module is essentially equivalent to an OpenFlexure Microscope.
You can download all of the STLs on this page as a single zipfile