Bill of Materials
Download this as a CSV file
Parts
- 1 100Ω resistor
- 3 28BYJ-48 micro geared stepper motor
- 1 2mm hex head screwdriver
- 6 cm of 3.2mm heat shrink
- 10 cm of 4.8mm heat shrink
- 6 cm of 6.4mm heat shrink
- 1 LED
- 4 M2.5x20mm standoff
- 4 M2.5x8mm screw
- 2 M2x6mm screws
- 6 M3 nut
- 8 M3 washer
- 3 M3x12mm screw
- 3 M3x25mm hex head screw
- 2 M3x6mm screw
- 2 M3x8mm screw
- 6 M4x6mm button head screw
- 3 O-ring
- 1 Raspberry Pi camera v2
- 1 Raspberry Pi power supply
- 1 Sangaboard
- 1 USB cable
- 40 cm of black 0.5A instrument wire
- 20 cm of black 4A instrument wire
- 3 brass M3 nut
- 1 condenser lens
- some electrical tape
- 1 female connector housing
- 2 female crimp terminal contact
- some insulating tape
- small amount light oil
- 1 objective lens
- 40 cm of red 0.5A instrument wire
- 20 cm of red 4A instrument wire
- 3 rubber feet
- Some solder
- 1 tube lens
Tools
- 1 1.5mm hex screwdriver
- 1 2.5mm hex screwdriver
- 1 2mm hex screwdriver
- 1 SW5 nut driver
- 1 craft knife
- 1 crimp
- 1 heat gun
- 1 small pliers
- 1 soldering iron
- 1 wire cutters
- 1 wire stripper
Printed tools
- 1 band tool
- 1 band tool holder
- 1 lens tool
- 1 nut tool
3D printed parts
- 1 Raspberry Pi & Sangaboard base
- 1 camera cover
- 1 condenser housing - Print in black.
- 3 feet - All three feet are in the one file.
- 1 illumination dovetail
- 3 large gear
- 1 main body
- 2 sample clip - Both sample clips are in the one file.
- 3 small gear - All three gears are in the one file.
- 1 transmission optics module casing - Print in black.