Bill of Materials

Download this as a CSV file

Parts

• 6 M3 washer
• small amount light oil
• 3 O-ring
• 3 M3x25mm hex head screw
• 3 brass M3 nut
• 5 M3x8mm screw
• 3 28BYJ-48 micro geared stepper motor
• some electrical tape
• 6 M4x6mm button head screw
• some insulating tape
• 1 Raspberry Pi power supply
• 20 cm of red 4A instrument wire
• 20 cm of black 4A instrument wire
• 6 cm of 4.8mm heat shrink
• 6 cm of 6.4mm heat shrink
• Some solder
• 8 M2.5x8mm screw
• 2 M2.5 washer
• 2 M2.5 nut
• 2 M2x6mm screw
• 4 M3 nut
• 1 Raspberry Pi camera v2
• 1 objective lens
• 1 tube lens
• 1 star LED
• 40 cm of red 0.5A instrument wire
• 40 cm of black 0.5A instrument wire
• 1 power supply
• 2 banana plug
• 1 condenser lens
• 1 excitation filter
• 1 emission filter
• 1 beamsplitter filter
• 4 M2.5x20mm standoff
• 1 Sangaboard
• 1 USB cable
• 3 rubber feet
• 1 2mm hex head screwdriver

Tools

• 1 wire cutters
• 1 craft knife
• 1 2.5mm hex screwdriver
• 1 3mm hex screwdriver
• 1 soldering iron
• 1 wire stripper
• 1 heat gun
• 1 2mm hex screwdriver
• 1 1.5mm hex screwdriver
• 1 oil glass cutter
• 1 small pliers
• 1 SW5 nut driver

Printed tools

• 1 band tool
• 1 band tool holder
• 1 nut tool
• 1 lens tool

3D printed parts

• 3 feet All three feet are in the one file.
• 3 large gear
• 1 main body
• 2 sample clip Both sample clips are in the one file.
• 3 small gear All three gears are in the one file.
• 1 camera cover
• 1 reflection optics module casing Print in black.
• 1 reflection illumination holder Print in black.
• 1 reflection illumination condenser Print in black.
• 1 filter cube Print in black.
• 1 Raspberry Pi & Sangaboard base

Previous page | Next page